[Geoqus] viewing results with Abaqus

[Bernard Monod]

Hi everyone,

I'm using Abaqus to simulate deformation in the upper crust. Basically  
I'm pushing a block against another one and I have a fault between the  
two blocks. The faults makes an angle with the shortening direction  
and the block is moving of 15 km.

I would like to see the results after each 2 km of shortening, and not  
only as a function of time history or frame.

Does anybody know how to do this ?

Thanks a lot

Bernard


-- 
Bernard Monod
Doctorant
UMR 5212-CNRS: Modélisation et Imagerie en Géosciences - Pau
Université de Pau et des Pays de l'Adour
Avenue de L'Université
64013 Pau cedex France
Tel: +33 (0)5 59 40 77 88